Bridge Ethernet RJ-45 over legacy Coaxial cable

The Gefen Ethernet Over Coaxial Sender and Receiver units send RJ-45 Ethernet over RG-59 or RG-6 Coax cable at a distance of up to a 1000 feet.

Ideal for legacy installations where Coaxial cable is already permanently in place, these devices breathe new life into remote network extensions where re-wiring is not possible.

How It Works

Connect your existing Ethernet network cables to the Ethernet Over Coaxial Sender unit, then plug in your Coaxial cable to the Coaxial jack on the Sender unit. At the other end of your Coaxial cable run, attach the Ethernet Over Coax Receiver unit and your network cables. Power-cycle your equipment. You will now receive Ethernet network signals at the end of your cable run as if you had cabled the run with Ethernet cables.

Note:  This device passes all 10/100BASE-T Ethernet network protocols (TCP/IP, NETBUEI, Microsoft Networking, etc.) at speeds of up to 200Mbps (Full duplex fast Ethernet).

Up to 4 Ethernet runs may be sent through the Bridge over a single length of Coaxial cable simultaneously.

Features:

• Supports up to 200 Mbps data transmission rate
• Four RJ-45 Ethernet ports
• Tri-level throughput indication

Specifications:

• Four Ethernet 10/100M ports
• One coaxial port
• Coax modulation frequency: 2 to 30 MHz
• Power consumption: 100-240 VAC , 0.15 A, 8 Watts max
• Shipping weight: 5 lbs.
• Dimensions: 4.7"W x 1.1"H x 4"D